*Amazon Price Tracker! The indicated cost of may have already changed. Check the current price - >
|Date||Minimum price||Maximum price||Average cost|
The Wheeler 89-Piece Set includes 2 magnetized screwdriver handles, making swapping bits a simple process. 54 flat bits 8 Allen bits, sizes ranging from 1/16" to 3/16" 4 Phillips bits, #0, #1, #2, #3 3 Torx bits, T10, T15, T20 Weaver/Ruger scope ring clamp bit Redfield windage screw bit, Leupold windage screw bit Mauser stock cross bolt bit Millett rear sight adjustment bit Ruger/Colt single action base pin latch nut bit M1/M14/M1A rear sight bit Hinged storage box 3" shaft extension Hex to square drive adapter Two each of the very thinnest bits in this set, this is intentional as the thinnest are most likely to break 1911 grip screw bushing driver .062" pin punch, .093" pin punch, .118" pin punch Remington 870/1100/1187 trigger plate pin punch 2" #2 Phillips Glock replacement front sight screw bit S&W rebound spring compressor tool Wheeler's Gunsmithing Screwdriver Set is the kit that belongs on every gunsmithing bench. The well thought-out bit selection will put an end to burred, buggered and busted up screw slots on any gun that comes your way. The bits make up the heart of any screwdriver set and Wheeler's are the finest available. They're made from S2 tool steel and hardened to 56-58 Rockwell "C." Unlike other screwdriver suppliers, Wheeler's engineers measured the screws on over one hundred modern and antique firearms to make sure that we offered bits for every situation. Whether you're working on a Browning Superposed, a Remington 700, a Smith & Wesson revolver, or a Colt Single Action, you'll find that there's a bit to fit every screw on your gun. No implied or express warranty.